Piper Cherokee LANCE, Service Manual

Page: 771 / 854

PIPER CHEROKEE SIX / LANCE SERVICE MANUAL
03/27/08 III - INSPECTION
4D13
TABLE III-II. INSPECTION REPORT - PA-32R-300 (cont.)
Inspection
NATURE OF INSPECTION Interval (Hrs)
50 100
E. WING GROUP (CONT.)
18. Inspect all controls, air ducts, electrical leads, lines, and attaching parts
for security, routing, chafing, deterioration, wear, and correct installation ........... O
19. Install inspection plates and fairings...................................................................... O
F. LANDING GEAR GROUP
1. Check oleo struts for proper extension and evidence of fluid leakage.
(See Landing Gear System, Section II.).................................................................
O O
2. Inspect nose gear steering control and travel ......................................................... O
3. Inspect wheel alignment ........................................................................................ O
4. Put airplane on jacks. (Refer to Section II.)........................................................... O
5. Inspect tires for cuts, uneven or excessive wear, and slippage .............................. O
6. Remove wheels; clean, inspect, and repack bearings ............................................ O
7. Inspect wheels for cracks, corrosion, and broken bolts ......................................... O
8. Check tire pressure. (See Table II-I.) ..................................................................... O O
9. Inspect brake lining and disc for condition and wear. (See Paragraph 6-31.)........ O
10. Inspect brake backing plates for condition and wear ............................................. O
11. Inspect brake and hydraulic lines for condition and security................................. O
12. Inspect shimmy dampener operation ..................................................................... O
13. Inspect gear forks for damage................................................................................ O
14. Inspect gear struts, attachments, torque links, retraction links and bolts
for condition and security ...................................................................................... O
15. Inspect downlock for operation and adjustment .................................................... O
16. Inspect torque link bolts and bushings. Rebush as required .................................. O
17. Inspect gear doors and attachments ....................................................................... O
18. Inspect warning horn and light for operation......................................................... O
19. Retract gear - inspect operation ............................................................................. O
20. Retract gear - check doors for clearance and operation ......................................... O
21. Inspect anti-retraction system ................................................................................ O
22. Inspect actuating cylinders for leaks and security ................................................. O
23. Inspect all hydraulic lines, electrical leads, and attaching parts for condition
and security (i.e. - routing, chafing, damage, wear, etc.) ...................................... O
24. Inspect position indicator switch and electrical leads for security......................... O
25. Lubricate per Lubrication Chart, Section II ........................................................... O O
26. Remove airplane from jacks .................................................................................. O
G. SPECIAL INSPECTIONS
See Paragraph 8, Special Inspections, Requirements, below.