Piper Cherokee LANCE, Service Manual

Page: 287 / 854

PIPER CHEROKEE SIX / LANCE SERVICE MANUAL
03/27/08 VI - LANDING GEAR AND BRAKE SYSTEM
(PA-32-260/300)
2B19
6-43. ASSEMBLY OF BRAKE CYLINDER.
a. Cleveland cylinder number 10-20. (Refer to Figure 6-14.)
NOTE: Use a small amount of hydraulic fluid (MIL-PRF-5606) on the O-ring and component parts
to prevent damage and ease of handling during reassembly.
1. Install new O-rings on the inside and outside of the packing gland (9) and on the outside of the
piston (5).
2. To assemble the piston rod assembly, install on the rod (11), in order, the roll pin (15), return
spring retainer washer (14), return spring (12), packing gland (9) with O-rings, seal (7), piston
(5) with O-rings, spring (4) and retainer bushing (3). Secure these pieces with the small ring
(2) on the end of the rod.
3. Insert the piston rod assembly in the cylinder (1) and secure packing (9).
4. Install the cylinder per Paragraph 6-44.
b. Cleveland cylinder number 10-27. (Refer to Figure 6-15.)
1. Install new O-rings on the inside and outside of the packing gland (7) and on the outside of the
piston (3).
2. To assemble the piston rod assembly, install on the rod (13), in order, the roll pin (15), washer
(14), spring (11), washer (9), packing gland (7), seal (5), piston assembly (3), spring (2), and
roll pin (12).
3. Insert the piston rod assembly in the cylinder (1) and secure with the snap ring (10).
4. Install the cylinder per Paragraph 6-44.
c. Cleveland cylinder number 10-30. (Refer to Figure 6-15a.)
1. Install new O-rings on the inside and outside of the packing gland (7) and on the outside of the
piston (3).
2. To assemble the piston rod assembly, install on the rod (12), in order, the roll pin (15), washer
(14), spring (13), washer (11), packing gland (8), with O-rings, seal (7), piston assembly (6)
with O-ring, spring (4), sleeve (3), and retaining ring (2).
3. Insert the piston rod assembly in the cylinder (1) and secure with the retaining ring (10).
4. Install the cylinder per Paragraph 6-44.
d. Gar-Kenyon cylinder number 17000. (Refer to Figure 6-15b.)
1. Install new O-rings on the inside and outside of the fitting (8) and on the outside of the piston
(6).
2. To assemble the piston rod assembly, install on the rod (12), in order, the roll pin (14), return
spring retainer washer (13), return spring (11), fitting (8) with O-rings, seal (7), piston (6) with
O-ring, spring (4) and sleeve (3). Secure these pieces with the retaining ring (2) on the end of
the rod.
3. Insert the piston rod assembly in the cylinder (1) and secure fitting (8).
4. Install the cylinder per Paragraph 6-44.