Piper Cherokee LANCE, Service Manual

Page: 92 / 854

PIPER CHEROKEE SIX / LANCE SERVICE MANUAL
IV - STRUCTURES 03/27/08
1E8
9. At left wing, connect pitot tubes at wing butt line. If heated, the plus lead must be connected at
the fuselage.
10. Connect the brake lines to fittings within the cockpit at the leading edge of the wing and torque
“B” nuts.
11. In PA-32Rs, connect the hydraulic lines within the fuselage aft of the spar carrythrough and
torque “B” nuts.
12. Connect the electrical leads to the appropriate posts on the terminal strip, reinstall clamps and
ties to secure harness, reinstall terminal strip dust cover.
13. Connect fuel lines at wing butt line and torque “B” nuts.
14. Connect aileron balance and drive cables at point of disassembly, install cotter pins and cable
guards at pulley brackets.
15. Connect flaps by placing flap handle in the full UP position, place the bushing on the outside
of the rod end bearings, insert and tighten bolts.
16. Check the rigging and control cable tension of the ailerons and flaps.
17. Refill and service the brake system to assure proper operation.
18. In PA-32Rs, refill and service the hydraulic system and perform a gear function check.
19. Refill and service the fuel system, check for leaks.
20. Check the operation of all electrical equipment.
21. Perform a leak and function check on the pitot system.
22. Remove aircraft from Jacks.
23. Install interior side panels, spar carrythrough carpet, seatboard (if applicable), front and aft
seats and seat track stops as required.
24. Check pilot's and co-pilot’s seat operation.
25. Install wing to fuselage seal, and wing access panels.
26. Ground run aircraft to verify proper operation of fuel and brake systems.