Additional information
07
124
En
No picture is
displayed or the
picture is not
displayed properly.
Is the video cable properly
connected?
Insert the cable firmly and all the way in.
Is the video cable damaged?
If the cable is damaged, replace it with a new one.
Is the input setting on the
connected TV or AV receiver or
amplifier right?
Read the operating instructions of the connected
components and switch to the proper input.
Are the terminals for outputting
video signals properly set?
Press
VIDEO SELECT
to switch the terminal from which the
video signals are output.
Is the output video resolution
properly set?
Depending on the player’s output video resolution, the
picture may not be displayed at all or displayed properly. Use
OUTPUT RESOLUTION
to switch to a resolution at which
the picture is displayed properly (page 87).
Is the player connected with an
HDMI cable other than a High
Speed HDMI™ cable (with a
Standard HDMI™ cable)?
Press
STOP
while pressing
PLAY
on the player’s front
panel to restore the video outputs to the factory default
settings. After this, use the Setup Navigator to reset the
player.
There are some BDs for which the picture will only be output
when connected by HDMI cable.
Does the connected TV support
the frame rate of the video signal
being output by the player?
If the picture is not displayed when playing a disc with a
frame rate that is not supported, the picture will not be
displayed even when playback is stopped. In this case, use
the procedure below to switch the frame rate of the video
signals output from the player. Eject the disc and close the
disc tray. Then, press
OPEN/CLOSE
while pressing
PLAY
on the player’s front panel to switch to a frame rate
supported by the connected TV.
Is
NTSC on PAL TV
properly set? Set
NTSC on PAL TV
properly (page 109).
Picture is stretched.
Aspect ratio cannot
be switched.
Is the TV’s aspect ratio properly
set?
Read the TV’s operating instructions and set the TV’s aspect
ratio properly.
Is
4:3 Video Out
properly set?
• Set
4:3 Video Out
properly (page 108).
• When video signals with a resolution of 1080/50i, 1080/
50p, 720/50p, 1080/24p, 1080/60i, 1080/60p or 720/60p are
being output from the
HDMI OUT
terminal or the
COMPONENT VIDEO
output terminals, they may be output
with an aspect ratio of 16:9 even if
TV Aspect Ratio
is set to
4:3 (Standard)
(page 87).
Sound and picture are
not synchronized.
Is
Output Terminal Priority
properly set?
Set
Output Terminal Priority
properly (pages 83 and 119).
Picture is disturbed
during playback.
Picture is dark.
• This player supports Macrovision analog copy protection
technology. With some TVs (such as with built-in video
deck), the picture will not be displayed properly when the
copy protected DVD title is played. This is not a malfunction.
• If the player and TV are connected via a DVD recorder/
video deck, etc., the picture will not be displayed properly
due to analog copy protection. Connect the player and TV
directly.
Problem
Check
Remedy
LX03BD_2.book Page 124 Monday, July 28, 2008 4:30 PM
