Additional information
12
124
En
SIRIUS radio messages
If the problem is not solved after the troubleshooting above, if the screen freezes unexpectedly or
if the buttons on the remote control or front panel stop working completely, do the following:
• Press
STANDBY/ON
on the front panel to turn off the power, then turn the power back on.
• If the power cannot be turned off, press and hold
STANDBY/ON
on the front panel for over
10 seconds. The power will turn off. (In this case, the various settings made on the receiver may
be cleared.)
About SIRIUS
SIRIUS, XM and all related marks and logos are
trademarks of Sirius XM Radio Inc. and its
subsidiaries. All rights reserved. Service not
available in Alaska and Hawaii.
Cannot listen to Internet
radio stations. (“
File
Format Error
” shows in
the display.)
Broadcast is in a format not
compatible with this receiver.
This receiver cannot play audio in formats
other than MP3 or WMA. Also, even if they
are MP3 or WMA formats, this receiver may
not be able to play back.
The Internet radio settings
screen cannot be
displayed on the
computer’s Internet
browser.
This receiver’s IP address has not been
entered into the browser correctly.
Check the receiver’s IP address and enter it
correctly on the browser (page 108).
JavaScript is disabled on the
Internet browser.
Enable JavaScript.
The browser is not compatible with
JavaScript.
Use an Internet browser that is compatible
with JavaScript.
Symptoms
Causes
Remedies
Message
Cause
Action
Antenna Error
The SIRIUS antenna is not properly
connected.
Check that the antenna cable is attached
securely.
Check Sirius Tuner
The SiriusConnect™ tuner is not
properly connected.
Check that the 8 pin mini DIN cable and AC
Adapter are attached securely.
Acquiring Signal
The SIRIUS signal is too weak at the
current location.
Check for antenna obstructions and
reposition the SIRIUS antenna to get better
signal reception. Use the Antenna Aiming
option to optimize the antenna position.
Subscription Updating
Unit is updating subscription.
Wait until the encryption code has been
updated.
Updating Channels
Unit is updating channels.
Wait until the encryption code has been
updated.
Invalid Channel
Selected channel is not available/
does not exist.
Select another channel.
Firmware Updating
The SiriusConnect™ tuner’s
firmware is being updated.
Wait for updating to finish.
VSX-31_30_UC.book 124 ページ ２０１０年８月２５日 水曜日 午前９時２８分
