Additional information
12
119
En
Remote control
During playback of DVD-
Audio, the display shows
PCM
.
• This will occur when playing DVD-Audio material over the HDMI connection.
This is not a malfunction.
The power turns off
automatically and some
indicator flashes, or some
indicator flashes and the
power does not turn on.
• See the
Power
section (page 112).
Symptom
Remedy
Symptom
Remedy
Cannot be remote controlled. • Set the remote control unit’s remote control mode so that it matches the
setting on the receiver (see
Operating multiple receivers
on page 81).
• Check whether the receiver’s remote control mode is properly set (see
Remote Control Mode Setup
on page 111).
• Try replacing the batteries in the remote control (see
Loading the batteries
on
page 8).
• Be sure to operate within 7 m (23 feet) and a 30º angle of the remote sensor
on the front panel (see
Operating range of remote control unit
on page 14).
• Check that there are no obstacles between the receiver and the remote
control.
• Make sure that there is no fluorescent or other strong light shining on to the
remote sensor.
• Check the connections of the
CONTROL IN
jacks (see
Operating other Pioneer
components with this unit’s sensor
on page 39).
Other components can’t be
operated with the system
remote.
• If the battery ran down, the preset codes may have been cleared. Re-enter the
preset codes.
• The preset code may be incorrect. Redo the procedure for entering preset
codes.
VSX-31_30_UC.book 119 ページ ２０１０年８月２５日 水曜日 午前９時２８分
