The Advanced MCACC menu
10
91
En
Automatic MCACC (Expert)
If your setup requires more detailed settings
than those provided in
Automatically
conducting optimum sound tuning (Auto
MCACC
on page 41, you can customize your
setup options below. You can calibrate your
system differently for up to six different MCACC
presets
1
, which are useful if you have different
listening positions depending on the type of
source (for example, watching movies from a
sofa, or playing a video game close to the TV).
2
Important
• Make sure the microphone/speakers are
not moved during the Auto MCACC Setup.
• Using the Auto MCACC Setup will
overwrite any existing settings for the
MCACC preset you select.
3
• The screen saver will automatically appear
after five minutes of inactivity.
CAUTION
• The test tones used in the Auto MCACC
Setup are output at high volume.
1
Select ‘Auto MCACC’ from the Advanced
MCACC menu, then press ENTER.
If the
Advanced MCACC
screen is not
displayed, refer to
Making receiver settings from
the Advanced MCACC menu
on page 90.
2
Select the parameters you want to set.
Use
/
to select the item, then use
/
to
set.
•
Auto MCACC
– The default is
ALL
(recommended), but you can limit the
system calibration to only one setting (to
save time) if you want.
4
The available
options are
ALL
,
Keep SP System
,
5
Speaker Setting
,
Channel Level
,
Speaker Distance
and
EQ Pro & S-Wave
.
•
EQ Type
(only available when the
Auto
MCACC
Menu above is
EQ Pro & S-Wave
)
– This determines how the frequency
balance is adjusted.
Note
1 These are stored in memory and referred to as
MEMORY1
to
MEMORY6
until you rename them in
Data Management
on page 102.
2 You may also want to have separate calibration settings for the same listening position, depending on how you’re
using your system.
3 Except in cases where you are only adjusting one parameter (i.e. channel level) from the
Auto MCACC
menu (step 2).
4 • When data measurement is taken (after selecting
ALL
or
Keep SP System
), the reverb characteristics data (both
before- and after-calibration) that this receiver had been storing will be overwritten. If you want to save the reverb
characteristics data before measuring, connect a USB memory device to this receiver and transfer the data.
• When measurement is taken of data other than
SYMMETRY
(after selecting
ALL
or
Keep SP System
), the data are
not measured after the correction. If you will need to measure after correction data, take the measurement using the
EQ Professional menu in the Manual MCACC setup (page 97).
• The
EQ Pro & S-Wave
measurement is also taken when
Keep SP System
or
EQ Pro & S-Wave
is selected. See
Acoustic Calibration EQ Professional
on page 97 for more on this.
• Either effect of Acoustic Calibration EQ Professional and Standing Wave can be switched on and off in the
respective MCACC preset. For details, see
Setting the Audio options
on page 72.
5 The
Keep SP System
option allows you to calibrate your system while leaving your current speaker setting (page 106)
unchanged.
VSX-31_30_UC.book 91 ページ ２０１０年８月２５日 水曜日 午前９時２８分
