Controlling the rest of your system
09
86
En
With Pioneer components, you don’t need to
program the power to switch off in a shutdown
sequence (except DVD recorders).
5
Repeat steps 3 to 4 to program a
sequence of up to five commands.
Programming mode will terminate
automatically when the 5 commands are
entered.
• If you press
R.SETUP
before programming
is completed, commands programmed up
to that point will be stored.
Using multi operations
1
Press MULTI OPERATION.
The LED flashes continuously.
2
Within five seconds, press an input
function button that has been set up with a
multi operation.
The receiver switches on (if it was in standby)
and the programmed multi operation is
performed automatically.
Using System off
1
Press MULTI OPERATION.
The LED flashes continuously.
2
Within five seconds, press
SOURCE.
The command sequence you programmed will
run, then all Pioneer components will switch
off
1
, followed by this receiver (switch of all the
zones becomes off).
Erasing the settings for the multi-
operation
This erases all the settings programmed in the
remote control for the multi-operation.
1
Press and hold R.SETUP, then press “8”
for three seconds.
The LED flashes continuously.
• To cancel the preset setup mode press
R.SETUP
.
2
Press the input function button
containing the program you want to cancel or
the
SOURCE button for three seconds.
If the LED lights for one second, the erasing
has been successfully completed.
Note
1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes
are sent.
VSX-31_30_UC.book 86 ページ ２０１０年８月２５日 水曜日 午前９時２８分
