Pioneer DVH-P5900MP, Operation Manual

Page: 78 / 96

Note
To adjust the speaker output levels in this mode is
the same as making the speaker output levels at
TEST TONE
. Both provide the same results.
Adjusting the speaker output
levels using a test tone
This function allows you to easily get the over-
all balance right among the speakers.
1 Press AUDIO and hold until FRONT ap-
pears in the display, then press AUDIO to
select TEST TONE.
2 Press
d
to start the test tone output.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
FRT-L (front speaker left)
—
CENTER (center
speaker)
—
FRT-R (front speaker right)
—
REAR-R (rear speaker right)
—
REAR-L (rear
speaker left)
—
SUB.W
(subwoofer)
#
Check each speaker output level. If no adjust-
ments are needed, perform step 4 to stop the test
tone.
#
The settings do not appear for speakers
whose size is set
OFF
. (Refer to Setting the speak-
er setting on page 76.)
3 Press
a
or
b
to adjust the speaker out-
put level.
Each press of
a
or
b
increases or decreases
the speaker output level. +10 to
–
10 is dis-
played as the level is increased or decreased.
#
The test tone rotates to the next speaker after
about two seconds from the last operation.
4 Press
c
to stop the test tone output.
5 Press BAND to return to the playback
display.
Notes
!
If needed, select speakers and adjust their
‘
ab-
solute
’
output levels. (Refer to Adjusting the
speaker output levels on the previous page.)
!
To adjust the speaker output levels in this
mode is the same as making the speaker out-
put levels at
FRT-L . Both provide the same re-
sults.
Using the time alignment
The time alignment lets you adjust the dis-
tance between each speaker and the listening
position.
1 Press AUDIO and hold until AT EQ ap-
pears in the display, then press AUDIO to
select TA.
2 Press
c
or
d
to select the time align-
ment.
!
TA INTIAL
–
Initial time alignment (factory
setting)
!
TA CUSTOM
–
Adjusted time alignment
that you can create for yourself
!
TA AUTO TA
–
Time alignment created by
auto TA and EQ. (Refer to Auto TA and EQ
(auto-time alignment and auto-equalizing)
on page 73.)
!
TA OFF
–
Turn the time alignment off
#
If auto TA and EQ have not been carried out,
SET A.TA
is displayed when
TA AUTO TA
is se-
lected.
3 Press BAND to cancel the time align-
ment mode.
Adjusting the time alignment
You can adjust the distance between each
speaker and the selected position.
Available accessories
En
78
Section
04