6
Press BAND to return to the playback
display.
Note
When playing a 2-channel mono source with Pro
Logic II turned on, there may be occasions when
the following will occur:
!
No audio is outputted if the center speaker
setting is
SML
or
LRG
and no center speaker
is installed.
!
Audio is heard only over the center speaker if
installed and the center speaker setting is
SML
or
LRG
.
Selecting a cross-over frequency
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to
SML
, you can select a fre-
quency, under which sounds are reproduced
through a
LRG
speaker or subwoofer.
1
Press AUDIO and hold until AT EQ ap-
pears in the display, then press AUDIO to
select HPF.
2
Press
c
or
d
to select the speaker to be
adjusted.
Each press of
c
or
d
selects the speaker in
the following order:
F
(front speakers)
—
C
(center speaker)
—
R
(rear speakers)
—
S
(subwoofer)
3
Press
a
or
b
to select cross-over fre-
quency for the selected speaker.
Each press of
a
or
b
selects cross-over fre-
quencies in the following order:
63
—
80
—
100
—
125
—
160
—
200
(Hz)
4
Press BAND to return to the playback
display.
Note
Selecting a cross-over frequency is to set a cross-
over frequency of the subwoofer
’
s L.P.F. (low-pass
filter) and that of the
SML
speaker H.P.F. (high-
pass filter). The cross-over frequency setting has
no effect if the subwoofer is set to
OFF
and other
speakers are set to
LRG
or
OFF
.
Adjusting the speaker output
levels
Speaker level can be adjusted finely by listen-
ing to an audio output. First, use test tone to
adjust the approximate speaker level, and then
use this function to adjust finely.
1
Press AUDIO and hold until AT EQ ap-
pears in the display, then press AUDIO to
select FRT-L.
2
Press
c
or
d
to select the speaker to be
adjusted.
Each press of
c
or
d
selects the speaker in
the following order:
FRT-L
(front speaker left)
—
CENTER
(center
speaker)
—
FRT-R
(front speaker right)
—
REAR-R
(rear speaker right)
—
REAR-L
(rear
speaker left)
—
SUB.W
(subwoofer)
#
You cannot select speakers whose size is set
at
OFF
. (Refer to
Setting the speaker setting
on
the previous page.)
3
Press
a
or
b
to adjust the speaker out-
put level.
Each press of
a
or
b
increases or decreases
the speaker output level.
+10
to
–
10
is dis-
played as the level is increased or decreased.
4
Press BAND to return to the playback
display.
Available accessories
En
77
Section
04
A
vailable
accessories
