Pioneer avh-4200nex, Owner'S Manual

Page: 58 / 244

58
Speaker leads
1
2








9
a
d
e
7
4 3
5
6
8
b
c
L R
F
R
1 To power supply
2
Power cord
3 Left
4
Right
5 Front speaker
6
Rear speaker
7 White
8
White/black
9 Gray
a
Gray/black
b Green
c
Green/black
d Violet
e
Violet/black
p
With a two-speaker system, do not connect anything to the
speaker leads that are not connected to speakers.
Notice for the blue/white lead
When the ignition switch is turned on (ACC ON), a control signal
is output through the blue/white lead. Connect to an external
power amp’s system remote control terminal, the auto-antenna
relay control terminal, or the antenna booster power control
terminal (max. 300 mA 12 V DC). The control signal is output
through the blue/white lead, even if the audio source is switched
off.
Important
When this product is in “ Power OFF ” mode, the control signal
is also turned off. If “ Power OFF ” mode is canceled, the
control signal is output again and the antenna is extended
with the auto antenna function (if the antenna is being used).
Be careful so that the extended antenna does not come into
contact with any obstacles.
Rear panel (main terminals)
a
9
8
1
6
4 3 2
7
5
1 This product
2
Fuse (10 A)
3 Power supply
4
Wired remote input
Hard-wired remote control adapter can be connected (sold
separately).
5
Antenna jack
6
SiriusXM Connect Vehicle Tuner
For details, refer to the instruction manual for SiriusXM
Connect Vehicle Tuner (sold separately).
7
iDatalink adapter input
For details, refer to the instruction manual for the iDatalink
adapter (sold separately).
8
Microphone 3 m (9 ft. 10 in.)
9 RGB cable (supplied with Navigation system)
a
Pioneer navigation system
Please contact your dealer to inquire about the connectable
navigation unit.
p
Before using and/or connecting the iDatalink Maestro
adapter, you will need to first flash the Maestro module with
the appropriate vehicle and head unit firmware. You can
find the device number that is required for the activation on
the followings (refer to Activating iDatalink Maestro on page
44):
— the label on the packaging of this product
— the label on this product
— the “ Firmware Information ” screen
Power cord
1
2
3
4
5
6
7
8
9
a
b
c
b
d
1
To power supply
2 Power cord
3
Yellow
To terminal supplied with power regardless of ignition switch
position.
4 Red
To electric terminal controlled by ignition switch (12 V DC)
ON/OFF.
5
Orange/white
To lighting switch terminal.
6
Black (ground)
To vehicle (metal) body.
7
Violet/white
Of the two lead wires connected to the back lamp, connect
the one in which the voltage changes when the gear shift
is in the REVERSE ( R ) position. This connection enables
the product to sense whether the car is moving forwards or
backwards.
8
Yellow/black
If you use an equipment with Mute function, wire this lead
to the Audio Mute lead on that equipment. If not, keep the
Audio Mute lead free of any connections.
9
Blue/white
Connect to system control terminal of the power amp (max.
300 mA 12 V DC).
a Light green
Used to detect the ON/OFF status of the parking brake. This
lead must be connected to the power supply side of the
parking brake switch.
b Power supply side
c
Parking brake switch
d Ground side
p
The position of the handbrake switch depends on the vehicle
model. For details, consult the vehicle Owner’s Manual or
dealer.
58 < CRD4943-A > < CRD4943-A >
Connection Connection