107
DRU10002 (REV 004 / JAN 2017)
Loosen the screw that secures the main analog board to the front panel, and
then carefully remove the analog board.
On the board, locate the configuration pins with the designation
JP2
. There is
a small jumper that can be used to short together one of three pairs of pins.
Place the jumper across one of the three pairs of pins at
JP2
. Choose the ratio
required for the particular potentiostat being used with the rotator.
1.0 RPM/mV
2.0 RPM/mV
4.0 RPM/mV
(Note: MSR rotator factory setting is 1.0 RPM/mV)
Summary of Contents for MSR 636A
Page 2: ......