Doc
ID:
3323299
Rev:
C
Title:
LPCR2 Service Process Work Instruction
17 of 23
Work
1
1
st
Verify
2
2
nd
Verify
Tool
!
Caution
Shock
Hazard
E
N
S
W
Orient
Clean
Scan
Template: 7000743_B
5.
Unable to change/update the device setup options
•
Browser version issue
– Internet Explorer version 10 or above; Google Chrome version 44 or below; any version of Mozilla Firefox are the supported
browser versions to run setup options. If the browser version is not in the specified version, the setup option window will not work.
•
Account specific issue
– ASR or SmartDesk will assist with account issues.
6.
Using Voice Prompts for Troubleshooting
Overview
: The following table contains a list of voice prompts that may be heard during troubleshooting.
Steps
: To enter device troubleshooting mode (Data Mode),
1. Open the lid
2. After hearing the voice prompts start, press and hold
LANGUAGE
and
CHILD
buttons simultaneously for at least 2 seconds to enter data mode.
NOTE
: There is a limited time window during which the
LPCR2
will accept the two-button press. Only press the two buttons after the voice prompts start and within 20
seconds after the voice prompts start. If “Device Ready” or “Device Not Ready” is not heard, that means the time window to accept the two-button press has been
missed. Close the lid and try again.
There are additional voice prompts that are used during a cardiac arrest event. See LIFEPAK CR2 Defibrillator Operating Instructions (CAT 26500-003800 or 26500-
003754) for the complete list of voice prompts.
Device
Troubleshooting:
Voice Prompt
Description
Device Ready
Readiness Status is OK. The device is ready for use.
Device Not Ready
Readiness Status is not OK. The device is not ready for use.
Call Service
Device has detected an issue that requires assistance from
authorized service personnel. Contact your local Physio-
Control representative or local authorized distributor for
assistance.
Replace Battery
The battery is low and should be replaced as soon as possible.
Replace Electrode tray
The electrodes have been used or expired and should be
replaced as soon as possible.
Wi-Fi Troubleshooting:
Voice Prompt
Description
Wi-Fi not Configured
Wi-Fi settings in the device have not been configured. Use Wi-
Fi Configuration Tool to store Wi-Fi settings on LPCR2.
Wi-Fi Connection Initiated
The device is connecting to a Wi-Fi network.