Doc
ID:
3323299
Rev:
C
Title:
LPCR2 Service Process Work Instruction
18 of 23
Work
1
1
st
Verify
2
2
nd
Verify
Tool
!
Caution
Shock
Hazard
E
N
S
W
Orient
Clean
Scan
Template: 7000743_B
Connection in Progress
After completion of "Wi-Fi Connection Initiated", the device will
attempt to establish a Wi-Fi connection to LIFENET. During
connection attempt, device beeps every 5 seconds.
Unable to Establish Wi-Fi
Network
The device is unable to connect to a Wi-Fi network. See
“Unable to establish Wi-Fi network connection” section for
details.
Connection Failed
Connection between Wi-Fi access point to LIFENET timeout.
This voice prompt means the
LPCR2
can reach the Wi-Fi
access point, but it cannot connect to LIFELINK or LIFENET
System. See “Connection Failed” section for details.
LIFENET Connection Error
An error has occurred while attempting to connect to LIFELINK
or LIFENET System. Contact SmartDesk for support.
Connection Established
The device has established a connection with LIFELINKcentral
AED Program Manager or LIFENET System. First HTTP
response is an OK. Start LIFENET Check-In after the
completion of "Connection Established"
This May Take Several Minutes
Informs user to allow several minutes for updates to complete.
After the completion of "Connection Established" and before
performing LIFENET Check-In. During LIFENET Check-In,
device will beep every 5 seconds.
Update in Progress
A software update is being downloaded and installed to the
device.
Rebooting
Informs user that the software update is complete and the
device is rebooting. Software shall reboot after this prompt.
When reboot is done, "Wi-Fi connection Initiated" prompt plays
again.
Communication Complete
After LIFENET Check-In completes. The device has finished
communicating with LIFELINKcentral AED Program Manager
or LIFENET System.
Connection Lost
The device has lost its connection to LIFELINKcentral AED
Program Manager or LIFENET System. If current LIFENET
Check-In session aborts after a successful LIFENET
connection has been established. Try again, if the same voice
prompt occurs, contact SmartDesk for support.
Powering Off
Informs user that the device is turning off. After completion of
Wi-Fi Troubleshooting, if no Cell configured on the device.(If
cell is configured, this prompt is heard after cellular connection.
See cellular troubleshooting.)