Section 2 - Installation
If you ever forget your admin password or have any other reason to reset the camera
to its factory settings, please use the following procedure:
Restore Camera back to factory settings
Make sure the camera is powered up.
Insert the tip of a paper clip in the
to press the reset switch.
Reset pin hole
You’ll feel the click when the switch engages.
A few seconds later the camera will restart and is now at factory settings. Of course,
after reset the user name and password will both be “admin” again.
It is easier to use the software reset function in the “Backup or Reset” menu.
If hardware reset is needed, find the
at the rear of camera.
Reset pin hole
Please see the figure in
section.
Hardware Overview
PHYLINK Cube HD User Manual
10
