Photron Fastcam MC1, Hardware Manual

Page: 90 / 141

Chapter 3. Recording
88
3.14. Signal Delay
A signal delay time or pulsewidth for the various signals that are input and output can be set on
the FASTCAM MC1. The procedure for making these settings is explained here.
■
TRIG TTL IN DELAY
Setting Range: 0-60 (s), in 100 ns units
Set from the SYNC IN/OUT submenu, TRIG TTL IN DELAY .
A pre-specified delay is implemented from the instant the trigger signal is input, the camera will
recognize and respond to the trigger input only after the specified amount of time set has elapsed.
Increase or decrease the value with the ARROW
↑↓
keys, move the digit with the
←→
keys.
■
SYNC IN DELAY
Setting Range: 0-1/frame rate (s), in 100 ns units
Set from the SYNC IN/OUT submenu, SYNC IN DELAY .
From the instant the synchronization signal is input, the camera will recognize the
synchronization signal later than normal, after the specified amount of time set has elapsed.
Increase or decrease the value with the ARROW
↑↓
keys, move the digit with the
←→
keys.
■
TRIG OUT WIDTH
Setting Range: 0-1 (ms), in 100 ns units
Set from the SYNC IN/OUT submenu, TRIG OUT WIDTH .
Set the output TTL signal’s pulsewidth (length). Increase or decrease the value with the ARROW
↑↓
keys, move the digit with the
←→
keys.