Photron Fastcam MC1, Hardware Manual

Page: 25 / 141

FASTCAM MC1 Hardware Manual
23
The FASTCAM MC1 is compatible with RS-422 control through the keypad connector.
A separate command list is available for the serial control commands. Please contact Photron or
the store where the system was purchased for the command list. (See: 9.1 Contracting Photron).
A cable is not offered as an accessory. When using RS-422 control, construct a cable using the
pin diagram below as a reference.
When using the connector pins directly, refer to the chart above and ensure the wiring is correct.
Incorrect wiring can cause malfunction.
The voltage on pin A (+12V OUT) is used to power the keypad, do not use it for other purposes.
By setting the STATUS OUT menu to ON, the system status can be output via the serial connection. For
details, check the command list.
[Keypad Pin Diagram]
PT02A-12-10S (023)
Connector
Name
Signal Name
Pin
Num.
Body-side Connector
Model Name (Maker)
Cable-side Connector
Model Name (Maker)
Input
Connector
+12V OUT A
SIGNAL GND B
RXD+ C
RXD- D
TRIGGER SW E
TXD- F
TXD+ G
POWER GND H
VBS GND J
VBS K
KEYPAD
PT02A-12-10S (023)
Amphnol
PT06A-12-10P (023)
Amphenol
NON