Phonak Audeo B Series, Training Manual

Page: 78 / 137

76 Phonak VA DALC Training Guide
Where to place EasyCall
II
• On the back of the phone.
• Near the bottom of the phone to ensure the microphone open-
ing is close to the mouth.
• On a solid area with no openings, such as microphones,
camera lens, speaker opening, etc.
Choosing the right tape
You have received 3 different tape pads along with the EasyCall.
For straight surfaces use the thin
transparent tape.
For curved surfaces use the
thicker black tape.
5 sec.
Attaching EasyCall
II
onto your cell phone
• Clean all dirt and grease off of
the phone and EasyCall to
ensure the tape holds well.
• Remove the backing from one side
of the double-sided adhesive tape.
• Carefully align and press the tape
against EasyCall.
• Remove the second backing and
place EasyCall on the best possible
position on your phone as shown
on the two previous pages.
• Gently press EasyCall against your
phone for 5 seconds to allow the
adhesive tape to bond.
Allow 20 minutes for the adhesive tape to hold EasyCall
properly. Full adhesive force is achieved after 24 hours.
The gray tape holds firmer than the black tape. Only use
it if you attach EasyCall onto an additional hard case
fitting your phone. It may be impossible to remove the
EasyCall from the phone later.
Covering an opening may negatively influence the
performance of the phone.