Phonak Audeo B Series, Training Manual

Page: 98 / 137

96 Phonak VA DALC Training Guide
0-10 cm /
0-4 inches
Connecting a receiver
Your hearing care professional may already have connected your
Roger Clip-On Mic with your hearing aids. If this is not the case,
connect your receiver to your Roger Clip-On Mic as follows:
1. Make sure Roger Clip-On Mic and the Roger receiver are
both powered on.
2. Hold Roger Clip-On Mic within 10 cm / 4 inches of the
Roger receiver.
3. Press the Connect button on your Roger Clip-On Mic.
4. The indicator light will turn green for two seconds to confirm
a successful connection.
5. Repeat steps 2 & 3 to connect a second receiver.
Clipped on the
collar
(clip downwards)
Clipped on
clothing
(clip upwards)
or or
Clipped between
buttons
(clip sideways)
max. 20 cm /
8 inches
Too far away Not pointing towards
the mouth
Wearing Roger Clip-On Mic
The easiest way to attach Roger Clip-On Mic to the
person speaking is by using its clip. There are different ways of
clipping Roger Clip-On Mic to the speaker’s clothes:
Using the lanyard
If it’s not possible to clip Roger Clip-On Mic to the speaker’s
clothing, you can alternatively use the lanyard to hang Roger
Clip-On Mic around their neck.
Attaching the lanyard
Press the Roger Clip-On Mic clip and slide the plastic part of the
lanyard over it.
Close the clip and make sure it is fully closed.
To remove the lanyard, open the clip and pull it out.
Indicator light (connection status)
After pressing the Connect button, the following feedback may
be given by the indicator light:
Indicator light (multiple microphone status)
When using multiple Roger microphones, the following feed-
back may be given by the indicator light:
Indicator light Meaning
Your Roger microphone is muted. Unmute it by
pressing the on / off button.
Your Roger microphone cannot detect the primary
Roger microphone. Switch on
the primary Roger microphone and make sure it is
within range of your Roger microphone.
Understanding Indicator Lights
Make sure Roger Clip-On Mic points towards the
speaker’s mouth.
Depending on the receiver type, you may connect a
maximum of two Roger ear-level receivers OR one Roger
MyLink to your Roger Clip-On Mic.