Phonak Audeo B Series, Training Manual

Page: 92 / 137

90 Phonak VA DALC Training Guide
2 secs
Switching on and off
To switch your Roger Pen on, press the on / off button for two
seconds until the indicator light turns white.
Using Roger receivers
Using Roger MyLink
If your Roger receiver is a Roger
MyLink, switch your Roger MyLink on
and hang it around your neck. Make
sure your hearing aids are set
to T / MT / T-Coil mode.
The Roger MyLink User Guide provides more detailed information
on using Roger MyLink.
Using Roger receivers attached to your hearing aids
If you have Roger receivers that attach
directly to your hearing aids, make sure
these are properly attached and each
hearing aid is set to its
Roger / FM / DAI / EXT / AUX program.
0-10 cm /
0-4 inches
Connecting a receiver
Your hearing care professional may already have
connected your Roger Pen to your hearing aids. If this is not the
case, connect your receiver to your Roger Pen
as follows:
1. Make sure Roger Pen and the Roger receiver are both powered on.
2. Hold Roger Pen within 10 cm / 4 inches of the Roger receiver.
3. Press the Connect
button on your Roger Pen.
4. The indicator light will turn green for two seconds to confirm a
successful connection.
5. Repeat steps 2 & 3 to connect a second receiver.
Meaning
Connection was successful – your Roger receiver
is connected to your Roger Pen.
Roger Pen could not find a Roger receiver. Move
Roger Pen closer to your Roger receiver and
make sure the Roger receiver is powered on.
Then try to connect again.
The Roger receiver is not compatible with your
Roger Pen.
Understanding Indicator Lights
Indicator light (connection status)
After pressing the Connect button, the following feedback may
be given by the indicator light:
Indicator light
You can connect an infinite number of Roger receivers to
your Roger Pen.