Phonak Audeo B Series, Training Manual

Page: 76 / 137

74 Phonak VA DALC Training Guide
Phonak EasyCall
II
User Guide
Charging the battery
• Plug the larger end of the charging cable into the
universal power supply. Plug the smaller end into the
micro-USB port on EasyCall.
• Plug the power supply into a power outlet.
The indicator light is red during charging and will
turn green when charging is complete.
This may take up to 3 hours. If EasyCall is used while charging,
the charging may take longer.
Switching On or Off
Press and hold the call button
(2 sec.) to switch EasyCall on or off.
The indicator light
• will turn green when switching on.
• will turn red when switching off.
If a phone is not connected for 60 minutes, EasyCall will
automatically switch off.
Initial pairing to a cell phone
Before using EasyCall with a cell phone, the devices must first be
paired with each other.
• Make sure EasyCall and the cell phone are within
1 meter (3 ft.) range.
• Enable Bluetooth on the cell phone.
• To manually pair EasyCall,
press and hold the call button
for 10 seconds until the
indicator light starts to rapidly
blink blue.
• Start the pairing process on the phone within 1 minute
according to the phone user guide.
• Your phone shows a list of found Bluetooth devices.
Select “Phonak EasyCall” from this list and enter code “0000”
if prompted.
Completion of pairing
After successful pairing, the indicator light will stop rapidly
blinking blue. This can take up to 2 minutes but usually occurs
within a few seconds.
Pairing to another cell phone
To use EasyCall with another cell phone, manually start the
pairing again as described on the previous page.
EasyCall has a non-removable rechargeable battery.
The phone only needs to be paired once. It remains paired
after switching off.
If EasyCall has never been paired, it will automatically be
in pairing mode after switching on. This is indicated by a
rapidly blinking blue indicator light.
Release the button immediately after turning red to avoid
the start of Bluetooth pairing.
Pressing the button twice within 2 seconds will switch
on EasyCall.
The full performance of a new battery is achieved only
after three complete charge and discharge cycles.
It is safe to leave EasyCall connected to the
charger overnight.
Before using EasyCall for the first time, charge it for at
least 3 hours.