Phonak Audeo B Series, Training Manual

Page: 81 / 137

Phonak VA DALC Training Guide 79
Selecting the charging slot
The stand-alone TVLink II is delivered with the charging slot for
Phonak ComPilot II/ ComPilot streamer. If you have ComPilot Air II
Clip-On, change the slot using a Phillips head screwdriver no 1.
• Unscrew the bottom screw. Lift the charging slot as shown.
• Insert the other slot completely. Insert and gently tighten
the screw.
Supported audio formats
The Phonak TVLink
II
can be connected to any audio source
such as a TV or computer. It supports 3 different audio input
formats.
For best results, we recommend to use the optical or coaxial
connection if available on your audio device.
Optical (“Toslink”)
Digital signal
Fiber optic cable
Coaxial
Digital signal
RCA cable Analog
Analog signal
3.5 mm plug
Slow blink orange
Solid orange
Signal priorities
Typically only one audio cable is connected. If more than one cable
is connected and a signal is present, TVLink
II automatically selects
the best possible input in the following order:
1. Optical
2. Coaxial
3. Analog
TVLink II shows the selected input by an orange audio
indicator light:
Input selected
Input selected and audio available
B 3 1
Charging the streamer
To charge the streamer:
• Ensure the charging slot fits the Phonak streamer
• Insert the streamer gently into the charging slot of TVLink
II
.
Ensure the integrated plug is placed in the streamer charging
socket correctly.
ComPilot Air
II
ComPilot, ComPilot
II
Charging is complete when the streamer’s indicator light
turns solid green.
TVLink II User Guide
Completion of pairing
Wait until both indicator lights turn solid blue. This can take up
to 2 minutes but usually occurs within a few seconds.
Put TVLink II into pairing mode
To manually start pairing mode:
• Switch TVLink II on.
• Press the pairing button on the back,
and the main indicator light will start rapidly
blinking blue.
• Make sure TVLink II and the
streamer are within
1 meter (3 ft) range.
Two devices only need to be paired once. They
remain paired after switching off and will
automatically connect after being switched on again.
The TVLink II basestation can be paired to a maximum of
4 streaming devices. A fifth pairing will replace the first
paired device.
When using your streamer for the first time, charge it for
at least three hours.
Please ensure to always connect TVLink II to the audio
output of the audio source.
TVLink II will remain in pairing mode for two minutes or
until the pairing has been completed.
If TVLink
II
has never been paired, it will automatically
be in pairing mode after switching on. This is indicated
by a rapidly blinking blue main indicator light.
Even if the optical and coaxial cable are a single-wire, the
signal is in stereo.