Phonak Audeo B Series, Training Manual

Page: 84 / 137

82 Phonak VA DALC Training Guide
2.
1.
Before using the RemoteMic with a streamer for the first time, the
devices must first be paired with each other.
Put the streamer into pairing mode
With ComPilot Air
II :
• Turn on and press the volume
up button at the same time.
With ComPilot II :
• Turn on first. Press the connect
and volume up buttons
at the same time for 2 sec.
The rapidly blinking blue
indicator light confirms that
the streamer is in pairing mode.
1.
2.
Put RemoteMic into pairing mode
To manually start pairing mode:
• Switch the RemoteMic off.
• Press and hold the volume up button ( ).
• Turn the RemoteMic on while pushing
the ( ) button at the same time.
• Release the ( ) button when
the indicator light starts rapidly
blinking blue.
• Make sure the streamer and RemoteMic
are within a 1 meter (3 ft) range.
The RemoteMic will remain in pairing mode for
2 minutes or until the pairing has been completed.
Completion of pairing
Wait until both indicator lights turn solid blue. This can take up
to 2 minutes but usually occurs within a few seconds.
power audio
Information during operation
RemoteMic Streamer
Searching for paired device Solid green
Streaming Solid blue Solid blue
Pause mode Blink blue Blink blue
Pairing mode Rapid blink blue Rapid blink
blue
Understanding Indicator Light
RemoteMic power and battery information
Switching on Green for 2 seconds
Switching off Red for 2 seconds
Charging Solid red
Fully charged while charger
attached Solid green
Low battery warning Additional red short blinks
RemoteMic in sleep mode
or off Indicator light is not lit
at all
Pairing the RemoteMic
Switch the RemoteMic off and on again to turn the device
back on from sleep mode.
You only have to pair the devices once. They will remain
paired and will automatically connect after being turned
on again.
If the RemoteMic has never been paired, it will automati-
cally be in pairing mode for 30 minutes after turning on.
This is indicated by a rapidly blinking blue indicator light. If you have received the RemoteMic and the streamer in a
set, they are paired already.