Phoenix Contact UM IA THERMOMARK X1.1, User Manual

Page: 97 / 130

Description of Operating Elements
103180_00_ia PHOENIX CONTACT
3-9
English
3.4.3 Machine Parameters
These settings are set to optimum settings and must not be modified.
Table 3-5 Parameters of the
Setup
>
Machine param.
menu
Parameter Meaning Default
P
rinthead pos. X
Shift the entire print image perpendicular to the direction of the media.
0.0 mm
P
rinthead pos. Y
Shift the entire print image in the direction of the media. With positive values,
printing begins later in the direction of the media.
Shifting the print image in the direction of the media also affects the cutting
position. Correct the
Cut position
parameter by the same value in the
opposite direction.
0.0 mm
Tear-off pos.
Shift the tear-off position in the paper feed direction. If the value is positive, the
label strip is transported further out of the printer.
0.0 mm
Cutter
Configuration of the cutter.
Cut position:
Shift the cut position in relation to the rear edge of the label
from +9.9 mm to -9.9 mm.
If the offset value is set to "0", in theory the cut is made in the middle of the gap
between labels. In the case of positive offset values, the paper is transported
further before being cut, i.e., the distance from the cutting edge to the rear edge
of the label increases.
0.0 mm
Brightn. LCD
Brightness of the LCD from 1 to 10.
10
Contrast LCD
Contrast of the LCD from 4 to 8.
6
Time Powersave
Time between the last operation and activation of energysaving mode.
5 min
Debug modes
Operating mode, which supports the firmware programmer when localizing error
sources.
Off