Phoenix Contact UM IA THERMOMARK X1.1, User Manual

Page: 86 / 130

THERMOMARK X1.1
2-10
PHOENIX CONTACT 103180_00_ia
2.4.5 Fitting the Cutter (Optional Accessory)
The THERMOMARK X1-CUTTER is not supplied as standard. Ordering data can be found
on page A-5.
Notes on the Cutter
Mounting the Cutter
Figure 2-6 Mounting the cutter
Fitting the cutter • Switch off the THERMOMARK X1.1 and disconnect the mains plug.
• Insert the cutter (1) with the pins in the catch holes of the printer.
• Press the cutter against the printer. When you do this, the connector attached to the
cutter makes contact with the I/O connection of the printer.
• Secure the cutter (1) with the screw (2).
• Now set "Cut mode" in the CLIP PROJECT advanced software. To do this, select
"File... Print setup...". Highlight the THERMOMARK X1.1 and set "After each material"
under Cut Mode in Printer Parameters. Confirm with OK.
To run the THERMOMARK X1.1 subsequently without a cutter, you will need to undo
this setting in the software.
The cutter may only be fitted and removed when the printer is switched off.
The blades of the cutter are sharp. Risk of injury, especially when carrying out
maintenance work.
Only operate the cutter when it is mounted on the printer.
Do not cut any media that is wider or thicker than indicated in the specification.
Do not reach into the area of the moving blades during operation.
1
2