33
Störungen
Error
The scanned copy is printed out
with white or black stripes.
The copy of the scanned document
is mirror-inverted.
TRANSM. ERROR
Error report
NO CONNECTION
or
REDIAL FAILED
NO LOOP CURRENT
NO DIALTONE
When you lift the receiver of your
fax machine you do not hear the
dial tone.
busy
or
fax transmissions are constantly
interrupted
You cannot receive any faxes.
You cannot phone or send faxes.
Possible cause
The scanner was not placed correctly
on the document.
The scanner was moved in the wrong
direction.
The telephone connection is of poor
quality.
The recipient has a paper jam or has
run out of paper.
Your fax partner’s line is busy, does
not answer or a different device like
an answering device answers.
Improper installation or plug-in of
fax machine.
You are connected to a PABX system.
You have connected your telephone
cable to the socket identified with
EXT.
You have connected the telephone
cable to the socket marked with EXT.
Your fax correspondent has a fax
machine that cannot receive the usual
standard identifying signals.
You have set the number of rings too
high for the answering machine or
the total number of ringing signals
for a device without answering
machine.
You are operating your fax machine
on a private branch exchange and
have not set it accordingly.
Remedy
Press the scanner firmly against the
document or put the document on a
flat surface.
Move the scanner in the direction
marked with an arrow across the
document (symbol on the right side
of the scanner).
Try again or send the fax at reduced
speed (function 21).
Call your fax partner or try to
transmit at a later stage.
Try later or draw your fax partner’s
attention to a possible installation
fault.
Check the installation of your fax
machine.
Check the settings in function 15.
Connect your telephone cable to the
socket on the bottom of your fax
machine identified with LINE.
Plug the telephone cable into the
socket marked with LINE on the
base of the fax machine.
Try to send the fax manually: press
DIAL/
l
and dial the fax number.
You will hear the call being estab-
lished. If the recipient is using an
automatic answering device, wait
until you hear a tone after the pre-
recorded message. Press
START
.
Set the number of ringing signals for
the answering machine or the total
number of ringing signals with
function 31 or 32 to lower than five.
In function 15, select
PABX: ye
.
