background image

BC

 50 IR WIRELESS BACKUP CAMERA

INSTALLATION INSTRUCTIONS

Introduction

 WARNING

See the Important Safety and Product Information guide in the product box for product warnings and other 
important information.
Garmin

®

 strongly recommends having an experienced installer with the proper knowledge of electrical systems 

install the device. Incorrectly wiring the power cable can result in damage to the vehicle or the battery and can 
cause bodily injury.
This device is intended to enhance your situational awareness when used properly. If used improperly, you 
could become distracted by the display.
When connecting the power cable, do not remove the in-line fuse holder. To prevent the possibility of injury or 
product damage caused by fire or overheating, the appropriate fuse must be in place as indicated in the product 
specifications. In addition, connecting the power cable without the appropriate fuse in place voids the product 
warranty.

 CAUTION

To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling, 
cutting, or sanding.

NOTICE

When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vehicle.

These installation instructions do not apply to a specific vehicle type, and are meant as a guide when 
installing this product on your vehicle. For questions specific to your vehicle, you should contact the vehicle 
manufacturer.

Getting the Owner's Manual

The owner's manual includes instructions for using device features and accessing regulatory information.

Go to 

garmin.com/manuals/BC50IR

.

GUID-1C33CFFD-55D8-4B45-B3A8-79D0C0A7E83C v2

June

 2022

Summary of Contents for BC 50









Reviews: