Philips EasySense SNS210 MC, Installer/User Manual

Page: 38 / 56

38
List of Configuration Parameters (continued)
Daylight based control
When enabled, daylight-based dimming is activated to further enable
energy savings. With this feature, when there is plenty of daylight, light
output from the luminaire adjusts to maintain a certain light level.
Daylight based control is locally done for every light within a group. It can
be used even if Occupancy based control is disabled e.g. in Manual on/off
mode. Unless commissioned into the group, the sensor does not respond
to daylight. Out of the box, lights do not dim down in case there is
abundance daylight.
See also the section on “Daylight regulation”.
Hold time
It is a configurable timer that begins once occupancy is not detected
anymore. Lights continue to be at Eco-on level for a period set as Hold
Time, before dimming down to Background Light Level. If occupancy is
detected again during Hold Time, the timer stops and automated
occupancy cycle re-starts.
Prolong time
It is a configurable timer that keeps the lights at Background Light Level for a
time period set as Prolong Time before switching off. Prolong Time comes
into effect after the elapse of Hold Time period.
In case Group light behavior is set to Eco-on level, lights in non-occupied
areas continue to remain to Eco-on light level. They dim down to
Background light level for 1 minute before switching off.
Infinite prolong time
When enabled, lights do not switch off and continue to be in Background
light level or Eco on level (when set via Group Light Behavior parameter)
Grace fading
It is the transition time period where the lights are being dimmed down
from the Eco on light level to the Background light level. This is a
configurable parameter and enables slow change of light levels for
improved comfort.
Color Temperature
This option is only available in combination with Tunable White fixtures with
FlexTune driver. This is the configurable Color temperature (CCT) of the
fixture when its turns ON based on Occupancy trigger or with short press of
the manual ZGP switch.