Philips EasySense SNS210 MC, Installer/User Manual

Page: 11 / 56

11
Grouping
Flashlight (Torchlight) commissioning
Purpose:
To select the luminaires in a room/building bwith flashlight/torchlight.
How to:
• Direct the light of a flashlight/torchlight to EasySense SNS210 sensor that you like to add to a group. The sensor is triggered by a sudden change from
relatively low light level to a higher light level.
• The smartphone responds to detection of light with a sound and a brief vibration. Now the BLE connection starts to setup. On the 2nd beep, the triggered
light dims down. In the app the selected light shows up with its Zigbee address and the number of added luminaires is increased by 1.
• Go to the next light to be added to the group and repeat the process.
• When all luminaires for a group have been selected, choose “Finish adding”. The number of devices that are bind to that group are now displayed in the
group overview.
Remarks:
• Use a flashlight/torchlight with a well-defined light cone and point
to the sensor from 3cm - 5cm distance only to cause a steep light
increase.
• Typically illuminance of the sensor should increase by
≥
5000lx
suddenly. A 500 Lumen flashlight is recommended.
• It is required to wait for 2 beeps, after which a light will show up in
Added menu. Wait for another 3 seconds before proceeding to the
next light.
• In case a light is not added with the flashlight, please re-try.
• If light remains unreachable, it might be that it was not in the
scan list because of a too big range, e.g. in case of a long corridor. A
re-scan of the lights with closer range is required to add this light to
the list. See “How to:” on page 10.
• It is strongly recommended not to change the flashlight sensitivity in
the App settings section.