PhaseOne iXM-MV100, Installation Manual

Page: 7 / 34

iXM-MV150F/iXM-MV100 Camera Systems Installation Guide
Page 7
Table 1 : Exposure Sequence
3.2 Wiring a Control Cable for the iXM MV Camera
Table 2: Control Cable Wiring
Typical Values iXM MV100 iXM MV150F
T1
Trigger IN SysRdy (Low)
2 ms SysRdy (Low)
2 ms
T2
Trigger IN – Start exposure 30 ms 30 ms
T3
Start Exp – End Exp T2 + Exposure time T2 + Exposure time
T4
Trigger IN – SysRdy High
(Cycle time)
12bit pixel depth:
290ms + Exposure time
14bit pixel depth:
390ms + Exposure time
16bit pixel depth:
800ms + Exposure time
12bit pixel depth:
390ms + Exposure time
14bit pixel depth:
520ms + Exposure time
16bit pixel depth:
Exposure time
Pin Color Name Description Direction Level Notes
1 Orange Reserved Reserved Reserved Reserved Reserved
2 Green System Ready Camera ready for
next capture.
Out VOH, min = 4.0V
(Io = -10uA)
VOL, max = 0.8V
(Io = 4mA)
5 Volt Level Pull up
resistor
47.5K Ohms to +5 V
3 Red
Black Reference
Control
Indicates a black
reference sequence
is required.
In VIH, min = 2.4V
VIL, max = 0.8VtiF,
tiR < 1uSec
Isolated. Active low.
See “Understanding
Black Reference” on
page 8
4 Purple Trigger In Trigger the
new capture cycle
In VIH, min = 2.4V
VIL, max = 0.8V
tiF, tiR < 1uSec
Active low.
(For manual triggering,
activate by short to
common signal,
otherwise leave floating)
5 Blue Reserved -- -- -- --
6 Yellow Reserved -- -- -- --
7 White
Light Trigger
Pulse
Marks start and stop
of exposure
Out VOH min = 4.0V
(Io= -4mA)
VOL max = 0.8V
(Io= 4mA)
5 Volt Level
8 Gray Reserved Reserved In Short to pin 9
9 Black Common Common