iXM-MV150F/iXM-MV100 Camera Systems
Installation Guide
Page 6
3
Setting up the iXM-MV Camera
3.1
Exposure Sequence
These signals control the iXM-MV150F/iXM-MV100 exposure sequence:
Hardware pulses
•
Trigger in
: Used for hardware triggering. It
signals the iXM-MV150F/iXM-MV100 to take
an image.
•
System ready
: Camera ready / busy output
signal. Returns to ‘high’ position shortly after
exposure (T3).
•
Light Trigger Output
: Signals the start
and
stop
of exposure.
This pulse is software
configurable
.
Delay Parameters for Global Reset (GR) Shutter Mode
(Software Configurable)
•
D1
: Delay time (-100us — +100us); Light trigger
pulse ON, to start integration (sensor reset).
•
D2:
Delay time (0 — +100us) Light trigger pulse
OFF, to start (sensor) readout.
3.1.1
Light Trigger Output Pulse for Global Reset (GR) Shutter Mode
The T2 and T3 trigger pulses can be software configured as follows:
•
Single pulse active low
: Starts exposure at signal ‘low’, stops exposure at signal
‘high’
Double pulse active low
: Starts and stops exposure at signal ‘low’
Single pulse active high
: Starts exposure at signal ‘high’, stops exposure at signal ‘low’
Double pulse active high
: Starts and stops exposure at signal ‘high’
1
2
3
4
