103
Driving
6
As a safety precaution, never leave the
vehicle with the engine running and the
doors closed.
Manual operation
► With the selector in position
D
, press
button
M
to enable 6-speed
sequential
gear changing.
The indicator lamp for the button comes on.
► Operate the "
+
" or "
-
" steering mounted
controls.
M
appears and the engaged gears are
shown in succession on the instrument
panel.
► You can revert to automatic operation at any
time by pressing button
M
again.
The indicator lamp for the button goes off.
In manual mode, there is no need to
release the accelerator pedal while
changing gear.
It is only possible to change from one
gear to another if the vehicle speed and
engine speed permit.
If the engine speed is too low or too high,
the selected gear flashes for a few
seconds, then the gear actually engaged is
shown.
When the vehicle is stationary or moving very
slowly, the gearbox automatically selects gear
M1
.
To preserve the brakes while descending
a steep incline, use engine braking to
reduce your speed (change down or select a
lower gear).
Keeping the brake pedal pressed
continuously for long periods can overheat
the brakes, with the risk of damaging the
braking system or making it inoperative.
Only use the brakes when necessary, to slow
or stop the vehicle.
Depending on the road configuration
(e.g. mountainous road), manual
operation may be preferable.
Automatic operation may not always be
suitable, and does not enable engine braking.
Invalid value during manual
operation
This symbol is displayed if a gear is not
engaged correctly (gear selector between
two positions).
► Place the selector "correctly" at a position.
Stopping the vehicle
Before switching off the engine, select position
P
then apply the parking brake to immobilise the
vehicle.
A point of resistance may be noticed
when moving to position
P
.
If the selector is not in position
P
when the
driver's door is opened or approximately
45 seconds after the ignition is switched off,
an audible signal sounds and a message
appears.
► Return the gear selector to position
P
;
the audible signal stops and the message
disappears.
On a steep slope with a loaded vehicle,
press the brake pedal
, select position
P
, apply the parking brake then release the
brake pedal.
In all circumstances, ensure that the
selector is in position
P
before leaving
your vehicle.
Operating fault
When the ignition is on, a message appears
in the instrument panel screen to indicate a
gearbox fault.
In this case, the gearbox switches to back-up
mode and is locked in 3
rd
gear. You may feel a
substantial knock when changing from
P
to
R
Summary of Contents for RIFTER
