Touch io Instruction Manual
Touch io Hardware
The
touch io
reader must be installed as part of the
pdk.io
cloud-based access control system. If it’s an
existing system, installing the new reader is a simple matter of removing the old reader and replacing it with
the
touch io
reader, using the same wiring. Once it is installed and wiring is connected, the reader displays a
yellow ring, indicating that setup with the mobile credentials is required. An existing prox card or key fob
from the old reader can be used immediately without any additional configuration.
NOTE
: Standard RFID credentialed prox cards and key fobs are not as secure as using a smart device for
touch io
access. Standard legacy prox cards can be cloned easily. The
is designed for
convenience, ease of use, and greater security.
Need additional information about any of the following?
Touch io Mounting Suggestions
●
If the
touch io
reader is used to control a door or pedestrian gate, locate the unit as near to the entry
point as practical.
●
If the reader unit is mounted on a wall adjacent to the entry point, be sure the wall is a suitably sturdy,
flat surface. The repeated shock and vibration from a slamming access door or spring-loaded pedestrian
gate MUST be isolated from the unit.
●
Never mount the
touch io
reader directly on a moving door or gate.
●
Choose a well-lit location near the controlled opening.
●
Wiring access for power, network, and earth ground MUST be available to the mounting location.
●
Touch io
supports both
and
installations and is suitable for both indoor and
outdoor use.
Need additional information about any of the following?
Page 19
