Paxar Monarch 1460, Reference Manual

Page: 201 / 217

C7. bat_voltage Selects the battery voltage. Options:
0 15-volt battery
1 12-volt battery
n
The printer’s LED does not flash after receiving this packet.
To check if the battery voltage changed, print a test label. The
selected printer remains active until a different printer is
selected or you turn the printer off.
Example
{
I
,C,0,0,0,0,768,1
p
}
Uses the default print contrast, does not adjust the print or
margin positions, prints at 2 inches per second, sets the
supply width to 4 inches, and specifies a 12-volt battery.
If the only parameter you need to change is the battery
voltage, make sure the printer is selected and ready to receive
data. Then, send this packet:
Example
{
I
,C,,,,,,1
p
}
Keeps your previously defined print control settings and
specifies a 12-volt battery.
Using Non-Addressed Mode––––––––––––––––––––––––––––––––––
In non-addressed mode, the printer uses a single
communication cable and does not need to be addressed or
selected before sending format and batch packets. To use a
printer in non-addressed mode, you must clear the printer’s
address. Make sure the printer is selected and ready to
receive data. Clear the printer’s address by sending this
packet:
Example
{
I
,F,,,,,,""
p
}
Keeps your previously defined communication settings and
clears the printer’s address. The address becomes 000000.
Your printer is ready to operate in non-addressed mode. You
can send format, batch, or any other MPCLII packets to the
printer.
MPCLII Packet Reference Manual
E-4