Ethernet Configuration window
88
Models 2616RC, 3096RC & 3196RC Admin Reference Guide
7 • Ethernet
Other Errors (dot3StatsInternalMacTransmitErrors)
The number of frames transmission on a fails due to an internal MAC sublayer transmit error.
Carrier Sense Errors (dot3StatsCarrierSenseErrors)
The number of times that the carrier sense condition was lost or never asserted when attempting to transmit a
frame on a particular interface.
Received Frames Too Long (dot3StatsFrameTooLongs)
The number of frames received that exceed the maximum permitted frame size.
Other Received Errors (dot3StatsInternalMacReceiveErrors)
The number of frames in which reception fails due to an internal MAC sublayer receive error.
Chip Set ID (dot3StatsEtherChipSet)
Ethernet-like interfaces are typically built out of several different chips. This value identifies the chip set that
gathers the transmit and receive statistics and error indications.
Ethernet Configuration window
The
Ethernet Parameters
section of the
Ethernet
Configuration
window (see
figure 33
) enables you to make
changes to the
Ethernet configuration. To reach this window, select
Modify Parameters
from the
Ethernet Over-
view
window (see
figure 31
on page 85).
Figure 33. Ethernet Configuration window
The following sections describe each parameter.
State (boxEtherAState)
Indicates the state of the Ethernet interface. The following states are valid:
•
notInstalled(0)—Ethernet interface is not physically present
•
noLinkIndication(1)—no cable is connected to Ethernet interface. Hub is not seen.
