PPP-IPCP Chassis Management Channel
165
Models 2616RC, 3096RC & 3196RC Admin Reference Guide
11 • In-band management
After the channel is UP, the
In-Band Mgmt
web page should appear similar to
figure 96
.
Figure 96. Defined In-Band Management Channels
The definitions of various columns are similar to the T1/E1 management channel described previously. For
Chassis Management Channels, only PPP is used. Frame Relay is not needed.
The
Interface Type
is
H.110 TX
/
H.110 RX
.
The statistics of the in-band management link are accessible via two paths. The first path is to click on the
hyperlink in the
Status
column. For the second, click on the hyperlink in the
Interface Type
, then click on the
hyperlink in the
Statistics
column.
Example 2: Bridged PPP (BCP) Chassis Management Channel
This example is to make a bridged-PPP chassis management channel between two Patton T-DACs. The chan-
nel will be:
Figure 97
shows how to configure the Model 2616RC for establishing a chassis management channel over the
midplane bus to the 3096RC in the same chassis.
Figure 97. Define an H.110 Management Channel
1.
The management channel will appear in the table as shown in
figure 98
. Notice that the Status is
DOWN
since the other end of the PPP link has not been created. We need to change the
Protocol Type
from
IPCP
to
BCP
.
Model 2616RC
to
Model 3096RC
Name: to3096RC
Name: to2616RC
BCP
BCP
IP Address: +10.10.1.2/32
IP Address: 10.10.1.3/32
2616RC
3096RC
Tx: H.110 Port 1:1
-------->
Rx: H.110 Port 1:1
Rx: H.110 Port 2:1
<--------
Tx: H.110 Port 2:1
Check Default Gateway box.