![background image](http://html1.mh-extra.com/html/parker/vix250cm/vix250cm_user-manual_755859038.webp)
30
VIX IM MICROSTEPPER INDEXER DRIVE USER GUIDE
Motor Overtemperature Sensor
Standard Parker stepper motors do not use an over-temperature sensor, however when
using custom motors provision is made for the connection of either a thermal switch or
thermistor device. The following devices are supported:
•
Thermik SNM130ES
•
Cantherm F11 110-2-5 U106
Other ptc thermistors with a switch like characteristic are supported to DIN44081/44082.
The input requires a normally closed switch to be connected to GND on X2 pin 3 or 6.
If you use a custom motor with no overtemperature sensor fitted, make sure you leave the
‘Thermal sensor fitted’ check box un-checked in the Custom Motor Set Up screen, within
Easi-V to prevent an overtemperature fault being reported. This is the default setting in
Easi-V.
X3 Connector
X3 is the RS232/RS485 communications connector. RJ45 connectors X6 and X7 may also
be used for inter-drive communications where multi-axis systems are used.
RS485 Operation
RS485 operation is only possible on drives fitted with the appropriate FEM (Fieldbus
Expansion Module). If you require this feature please order the ViX – CM drive type.
Connector Type
Connector type is a 9-way D-type socket.
Connector Pin Out
Connector Pin X3
Function
1
Rx+/Tx+ (RS485)
2
drive reset
3
RS232 GND
4
RS232 Rx
5
RS232 Tx
6
Rx-/Tx- (RS485)
7
RS232 Tx (D loop)
8
Do not connect
9
+5V output
Table 3-8. X3 RS232/RS485 Connections
Summary of Contents for ViX250CM
