Installation
4-12
AC30 series Variable Speed Inverter
5.
Fit gasket to the inverter so that an air-tight seal
will be made between the inverter and the
panel.
Through Panel Kits, can be purchased from
Parker using the following part numbers:
Frame D – LA502668
Frame E – LA502669
Frame F – LA502670
Frame G – LA502471
Frame H – LA502472
Frame J – LA502793
Frame K – not applicable
6.
Tighten all screws in place as shown, according
to panel insert requirements.
7.
At this stage you can wire the power cables, see
page 4-16.
Upper Terminal
Cover
Cover Front
Upper
GKP
Control Unit Terminal Cover
(Cover Front Lower)
Lower Terminal
Cover
Snap out to allow entry to the
braking terminals
Gasket
Summary of Contents for LINKnet AC30P
