6
3. Connecting the pump and mattress
4. Connecting to the bed with a bed link cable
The back raise/lower pressure relief function and bed power function can be used by connecting the product to a suitable bed
specified by Paramount Bed using a bed link cable.
Note
!
There is an upper coupling and a lower coupling.
When connecting them, connect the lower one and
then the upper one.
1
Diagonally insert the protrusions on the far side of the cou-
plings into the grooves in the pump ports and then firmly insert
the CPR levers straight on the near side until you hear a click.
2
After attaching the couplings, check that the red labels af-
fixed to the couplings cannot be seen from the two holes at
the side. (See the figure below.)
Pump
Red label does not appear
Coupling (upper, white)
Red label appears
Coupling (lower, black)
3
Fasten the snap buttons in two locations on the pump cover.
4
Close the cover zippers (two locations) and pull the operation
panel cable and bed link cable out of the cover from the cor-
ner of the cover between the zippers.
WARNING
z
Check that the pump and couplings (upper and low-
er) are connected properly. There is a risk of the
body pressure not being dispersed effectively.
z
Securely fasten the snap buttons of the pump cover to
fix the pump in the pump installation position. Improper
fixing may result in the pump falling down, causing injury
or damage or deformation. Damage may also result in a
short circuit, which may cause an electric shock or a fire.
CAUTION
Remove the pump before moving the product. There
is a risk of damage or deformation of the pump due to
falling.
Port
Insert diagonally
Protrusion
CPR lever
Zipper
Zipper
Pump
Snap button
Pump cover
WARNING
When using the bed link cable, check how to connect to the bed and perform the wiring cor-
rectly. The bed link cable may be damaged and cause an electric shock or fire due to getting
caught in a movable part, etc.
Operation panel cable
Operation panel cable
and bed link cable
and bed link cable
Click!
