High
Pressure
13
[Max. inflate mode] button
When automatic on is set: Flashes
When automatic on is not set: Off
Auto max. inflate mode setting
The position sensor detects when the user sits up, rolls over to a mattress edge, and
sits on the side of the bed, and then max. inflate mode turns on automatically.
1
Press the [Max. inflate mode] button at the top of the operation panel to en
-
able or disable the setting.
2
Press the Setting button to complete the setting.
Note
!
z
The range in which sitting on the side of the bed can be detected
in automatic max. inflate mode is an area at the mattress center
extending one third the length of the mattress.
z
When the back angle of the bed is 20° or more, only rolling
over to a mattress edge and sitting on the side of the bed are
detected. Sitting up is not detected.
z
The [Max. inflate mode] button flashes in blue and
is dis-
played on the status display screen during automatic max. in-
flate mode operation.
z
Automatic max. inflate mode can be turned off manually by
pressing the [Max. inflate mode] button during automatic max.
inflate mode operation. (Automatic max. inflate mode remains
set.)
z
The automatic max. inflate mode turns off automatically in the
following cases. (Automatic max. inflate mode remains set.)
•
When the user is still at the center of the mattress for 10 seconds
•
When the user is still at an edge of the mattress for 5 minutes.
• When 60 minutes elapse
z
Correct detection may not be possible depending on the oper-
ating environment and the movement and posture of the user.
How to turn manual max. inflate mode on
Press the [Max. inflate mode] button at the top of the operation
panel. The manual max. inflate mode turns on, the [Max. inflate
mode] button lights in blue, and the status display screen displays
the remaining time indication.
How to turn manual max. inflate mode off
Press the [Max. inflate mode] button during manual max. inflate mode oper
-
ation. The manual max. inflate mode turns off and display returns to normal
display.
*
The manual max. inflate mode will turn off automatically after 60 minutes elapses.
* The setting of each function is returned to the setting before the manual max.
inflate mode was turned on.
(Example)
3-3. Max. inflate mode
Increase the internal pressure of the air cells to make it easy to get on and off the bed, sit on the side of the bed, and change
posture. In addition, the small flow air cell (SF cell) are contracted.
When the user sits on the side of the bed, use the max. inflate mode so that the user can sit with a more stable posture.
3-4. Pressure relief function and bed power function
When the pump and bed are connected,
is displayed on the status display screen and the following functions turn on.
Pressure relief function
Relieve the pressure on the upper part of the body by changing the
pressure at high speed if the back raising or lowering operation is per-
formed when the angle of the back section of the bed is at 20˚ or more.
Bed power function
Supply power from the bed to the product through a bed link cable.
* The power cable of the product cannot be used when us-
ing this function.
3-5. Reset
Press the Setting button to switch to setting display and press and hold down the [Max. inflate mode] button. A beep sound is
output and the settings are reset to the initial settings.
Status display screen
(digital number)
When automatic max. inflate mode
operation:
is displayed.
When manual max. inflate mode
operation: Remaining time
indication is displayed.
4
FUNCTIONS AND OPERATING PROCEDURES
