Paradyne JetFusion 2008, User Manual

Page: 179 / 216

T r o u b l e s h o o t i n g a n d D i a g n o s t i c s 7-5
Symptom Probable Cause Corrective Action
Power indicator is not lit Power is not available
to the IAD Ensure the power cord is
securely connected.
Ensure the power cord is
plugged into a live outlet.
Ensure the power switch is on.
If powered by an adapter,
ensure the correct adapter is
used.
LAN Link indicator is not lit Incorrect Ethernet
connection Ensure an Ethernet cable is
properly connected to the IAD
and its upstream connection.
No dial tone is present
Incorrect PVC set for
voice channel Verify these settings:
VPI: 0 to 255
VCI: 0 to 65535
(default PVC 0/39)
IAD is improperly
provisioned at the
voice gateway
Incorrect network
provisioning
Incorrect directory
number at the Class 5
switch
Verify and correct
provisioning of IAD as
required (refer to page 5-2).
Check and correct network
provisioning at DSLAM,
network switches, etc.
Check and correct as required
Cannot receive or send data Incorrect PVC set for
data channel Verify these settings:
VPI: 0 to 255
VCI: 0 to 65535
(default PVC 0/38)
View Interface (page 5-12)
and Media statistics
(page 5-20) to check the pack
receive and send status.
Incorrect network
setup Check and correct network
setup as necessary.
If IAD is configured as a router:
Incorrect or missing
LAN or WAN IP
address Ensure that both the LAN and
WAN IP addresses are
configured.
Incorrect or missing
default static route Review the routing table and
correct as necessary
(page 5-26).