Paradyne JetFusion 2008, User Manual

Page: 67 / 216

C o n f i g u r a t i o n 4-13
Configure Payload Scrambling
You must enable payload scrambling (which is disabled by default) for the
IAD to connect to a DSLAM that uses payload scrambling. To enable or
disable payload scrambling, follow the steps below:
1
On the ATM Configuration menu, type
“1”
to see a prompt that lets you
enable or disable Payload Scrambling.
2
To enable payload scrambling type
“E”
, or type
“D”
to disable. The IAD
saves the configuration and displays the ATM Configuration menu where
you may continue with other ATM tasks.
Configure F4 OAM VPI
One F4 OAM VPI may be configured at a time. When you are configuring an
F4 OAM VPI, if one is not configured, the IAD displays the message, “F4
OAM not configured”; otherwise the current configuration is displayed.
To configure the F4 OAM VPI, follow the steps below.
1
On the ATM Configuration menu (Figure 4.13), type
“2”
to select
Configure F4 OAM VPI. This value must match one of the WAN PVCs.
For more information, refer to
Show Current PVCs on page 4-12. The IAD
displays the status and prompts you to enter a VPI.
2
Type the VPI on which to configure F4 OAM. The IAD saves the
configuration and displays the ATM Configuration menu where you may
continue with other ATM tasks.
Configure F4 OAM Type
To configure the F4 OAM Type, follow the steps below.
1
On the ATM Configuration menu (Figure 4.13), type
“3”
to select
Configure F4 OAM Type. The IAD displays the menu shown in Figure
4.14.
Figure 4.14 F4 OAM Type Configuration Menu
2
Type “0” to set F4 OAM to none, or type “4” to set for End to End OAM.
The IAD saves the configuration and displays the ATM Configuration menu
where you may continue with other ATM tasks.
Display F4 OAM Configuration
To display the F4 OAM Type currently set, type
“4”
on the ATM
Configuration menu (Figure 4.13). The IAD displays the status message, and
then displays the ATM Configuration menu.