5-2
2 0 0 0 - A 2 - G B 2 2 - 0 0
To display a report or group of reports, or to clear statistics for a particular
protocol or interface, select the option and refer to the details regarding each
option below.
NOTICE:
When viewing a report, press any key to display the next page, or return
to the Reports menu at the end of the report. Press Escape to return to
the Reports menu at any time.
Current Configuration Report
To display the Current Configuration report, enter
“C”
on the Reports menu
(Figure 5.1). The Current Configuration report displays configuration settings
and information about the installed interfaces on your IAD.
Details are displayed for each of the IAD’s ports and interfaces. The
parameters are repeated, and not described again in the table.
The information displayed in the Current Configuration report is listed in the
table below. The contents of this report vary based on the IAD configuration,
interfaces, and ports.
Parameter
Description
Software version
version of IAD firmware
Serial Number
serial number of the IAD
Contains # DSP chip(s)
no. of DSP chips in the IAD
Derived Timing
Status: enabled | disabled
Current Time
date, time
Routing Information Protocol
Status: enabled | disabled globally
Bridging
Status: enabled | disabled globally
Bridge Database Aging Time
1-3600 seconds (default 300 seconds)
Spanning Tree
enabled | disabled globally
Spanning Tree bridge priority
1-65,535 (default 32,768)
Spanning Tree hello time
1-10 seconds (default 2 seconds)
Spanning Tree max age
6-40 seconds (default 20 seconds)
Spanning Tree forward delay
4-30 seconds (default 15 seconds)
Simple Network Management
Protocol (SNMP) (IP and EOC)
Status: enabled | disabled
SNMP System Contact
user-defined (maximum 39 characters)
SNMP System Name
user-defined (maximum 39 characters)
SNMP System Location
user-defined (maximum 39 characters)
SNMP Community
name must match the SNMP host (maximum = 39
alphanumeric characters); If SNMP is enabled
and the SNMP Community Name is null, SNMP
goes into read-only mode.
SNMP Trap Host IP Address
IP address of the SNMP trap host
Summary of Contents for JetFusion 2008
