Paradyne JetFusion 2008, User Manual

Page: 127 / 216

C o n f i g u r a t i o n 4-73
Figure 4.60 NAT Local Server Protocol Configuration Menu
4
Type the option number of the protocol (usually TCP or UDP) to use. The
IAD displays the menu with the new status message.
5
Press Escape to continue. The IAD prompts you to enter the Translated Port
number:
6
Type the translated port number (range = 1-65535) and press Enter. The
IAD prompts you to enter the Local Server Standard Port number:
7
Type the Standard Port Number (range = 1-65535) and press Enter. If you
did
not choose TCP and UDP for protocol, the IAD displays the following
message:
Updating NAT Local Server entry 1, Translated IP address
95.4.4.4
Translated Port 100 is accessible as Standard Port 65535
If you chose TCP and UDP for protocol, the IAD prompts you to enter the
number of consecutive ports to use.
8
Type the number of consecutive ports to use and press Enter. The IAD
displays a port report, saves the NAT configuration, and displays the NAT
Configuration menu.
9
Continue with other NAT configuration tasks, or press Escape to return to
the Main menu.
Configure NAT Alias Entry
Each NAT alias entry allows a device on the LAN (inside of NAT) to be
accessible from the Internet via a unique IP address. The IAD only translates
IP addresses for alias entries—port numbers are not changed.
You can create up to seven direct public-to-private IP address mappings via
the NAT alias table.
First, assign each public IP address using option C
−
Configure Port IP
Address on the Router Configuration menu (Figure 4.16)
−
to entries 1
through 7 on the PVC with a 255.255.255.255 subnet mask. Next, make alias
entries to map each local IP address to a corresponding public IP address.
These NAT alias entries allow IP traffic to the public IP address to pass
directly through, port for port, to the corresponding private IP address.
To configure each NAT alias entry, follow the steps below.