Paradyne JetFusion 2008, User Manual

Page: 52 / 216

3-20 2 0 0 0 - A 2 - G B 2 2 - 0 0
Space Left in File System
To display the amount of free space in the file system (flash memory), type
“S”
on the File System menu. The IAD displays the free space.
Debug Menu
The Debug menu contains commands to set various debugging options.
Debugging should only be enabled specifically during a debugging or
monitoring session, and disabled when the session is complete. Enabling
multiple debugging options simultaneously slows IAD performance.
Debugging commands are reserved for use by Paradyne network engineers.
NOTICE:
The IAD menu interface contains utilities normally reserved for factory
maintenance and development. Before running any system debug
commands, consult your service representative.
File Transfer Menu
The File Transfer menu allows you to transfer groups of files to or from the
IAD. To display the File Transfer menu (see Figure 3.5 on page 3-13), type
“X”
on the Utilities menu. To perform a specific task, type the option and
proceed to the corresponding section below.
Load Boot ROM
1
Type “B” on the File Transfer menu to download the Boot ROM to the file
system on the IAD.
Figure 3.10 File Transfer Method Menu
2
Type
“1”
to use TFTP, or
“2”
to use XMODEM to transfer the file to the
IAD.
3
The IAD displays the prompts you for the IP address of the TFTP server.
4
Type the IP address of the TFTP server and press Enter.
5
The IAD displays the following prompt for the file name to transfer:
6
Type the name of the file and press Enter. To exit without transferring the
file, press Escape or Enter without typing the file name.
7
When XMODEM is selected, if the file is not located, the IAD prompts you
for the file transfer speed.
8
The IAD transfers the file via TFTP or XMODEM.