19
SETUP PROCEDURES (FIRMWARE)
■
Administrator Password Entry
If you log into the system in the administrator mode,
PS·Data communication setting, all reset, operator pass-
word check. and database copy will become available.
To activate the administrator mode, you need to enter the
administrator password.
Notes:
• The factory default of administrator password is “650”.
However, for security, you should change the password
setting. To change the setting, refer to p. 24.
• Take a note of your administrator password.
■
Setting Modes
If you power on the system controller while pressing the fol-
lowing buttons, the system will run in an associated setting
mode.
Notes:
• You cannot change the system from the following
modes (refer to the diagram) to the normal operation
mode. To start up the normal operation mode, turn off
the system controller, and then turn on the controller
again.
• The administrator password entry is required for the fol-
lowing modes.
* The panning, tilting, and zooming calibration settings are
not restored.
Buttons pressed
while
the power-on
2, 4, and 6
MON (ESC) and 6
MON (ESC) and 1
Administrator
password change
The administrator
password can be
changed.
Setting Mode
All reset
PS·Data
Communication
setting
Description
The communication
settings and
PS·Data database
can be restored to
the factory default.*
PS·Data communi-
cation setting can
be performed.
MON (ESC) and 2
MON (ESC) and 4
PS·Data database
copy
PS·Data password
display
The PS·Data data-
base can be copied
from the source
system controller
(Controller No. 1) to
a destination sys-
tem controller.
The passwords of
up to 16 operators
can be displayed
on the LCD.
Summary of Contents for WVCU650 - SYSTEM CONTROLLER ADDENDUM
Page 77: ...77 ...
