Panasonic WVCU550C - SYSTEM CONTROLLER UNIT, Operating Instructions Manual

Page: 24 / 130

26
2
●
Board Setting
Before installing this board, the following settings should be made by qualified service personnel or system installers.
CN13
CN12
SW4
CN14
1234
OFF
5678
SW2
1. Confirm that Switches (SW2) on the board are set as
follows.
1234
OFF
SW2
5678
2. Set switch (SW4) on the board to select either VD or VS
for the Sync input signal, if applicable.
The factory default setting is VS.
SW4
SW4
VS
VD
3. Position jumper connectors (CN12) on the board to
open connection position when a printer is connected
to the board.
4. Position jumper connector (CN13) on the board to the
“C/L” position when the setup menu tables are not
clearly displayed on the color monitor.
The factory default setting is “B/W”.
5. Position jumper connector (CN14) on the board to
select either VD Output or Status Display Output for the
VD Output Connector.
The factory default setting is VD.
These switches are used only for factory test.
Always keep these switches in the “OFF” positions
in the field.
Note
R
B
G
SYNC
CN12
CN13
B/W
C/L
CN13
CN14
GRAPHIC
VD
CN14