Panasonic Workio DP-3030, Service Manual

Page: 460 / 486

Network Firmware Update Tool (LAN)
3. Preparing the Firmware Update
3.1 Preparing the Unit to Accept the Firmware Code
3.1.1 For DX-600 / DX-800 (v1.31 or higher)
1.
If the device password is changed (Remote Password) from the default value (blank = 0000), it is
not possible to program the firmware code. In this case, enter the password in advance to the
Default Password in the Configuration dialog box or enter the password at each communication.
2.
Make sure the device is not in an operating condition (copying or printing etc...).
Note: It is recommended to update the firmware at night due to lower activity of the device.
3.1.2 For other models
1. If the device password is changed (Key Operator Password) from the default value (0000 or 000),
it is not possible to program the firmware code. In this case, enter the password in advance to the
Default Password in the Configuration dialog box or enter the password at each communication.
As for three-digit Key Operator Password device, only “000” of the default value is judged “0000” in
the value.
2. Make sure the device is not in an operating condition (copying or printing etc...).
Note: It is recommended to update the firmware at night due to lower activity of the device.
3.2 Preparing the Firmware Code
Copy the firmware Code file(s) to the following folder.
C:\Panasonic\Panasonic-FUP\Data
Note: The Archive File extracts the Firmware Code Files automatically into the designated folder.
(ex. DP-2310_PU_030327.exe)
Page 6