96
Symptom
Cause/solution
Reference
pages
The images or embedded characters
displayed on the monitor look blurry.
• Depending on the photographic subject or HDMI monitor that is
connected, images or embedded characters may look blurry.
That is not a trouble.
–
Cannot play back images.
• Are there any recorded images on the hard disk drives?
Check if there are recorded images.
75
• Users who have logged into the system may not be authorized to
playback images recorded on the hard disk drives.
Check the user level settings of these users.
71
• Users who have logged into the system may not be authorized to
display images from the cameras.
Check the user level settings of these users.
71
Audio is not output from the camera.
Or audio is accompanied by noise.
• Is the audio encoding format of the camera set to
"G.726(32kbps)"? This recorder supports "G.726(32kbps)" only.
Check the setting of the connected camera.
−
Cannot control the cameras.
• Check whether the camera numbers and IP addresses that are
displayed on the setup menu - the "Advanced setup" menu - the
[Camera] page - [Camera registration] tab.
46
• Check if the user name and password has correctly been entered
on the setup menu - the "Advanced setup" menu - the [Camera]
page - [Camera registration] tab.
47
No alarm action is taken.
• Check if alarm input signals are properly input to the ALARM/
CONTROL connector at the rear panel.
27
• Are the settings of the alarm terminals appropriate?
27
• Is "Off" or "Recording only" selected for "Mode"?
Check whether the settings are appropriate.
56
The "Communication error :cc" indi-
cation is displayed on the main mon-
itor.
• Confirm that the camera is connected correctly and firmly.
Check the camera connection.
23
• If the connection is appropriate, the cable may be broken or the
camera may be out of order. Consult the dealer.
−
The "Thermal error" indication is dis-
played on the main monitor.
• The ambient operating temperature is +5 °C to +45 °C {41 °F to
113 °F}. The "Thermal error" indication is displayed when the
ambient operating temperature e45 °C {113 °F}. If the
"Thermal error" indication is displayed, it is recommended to
change the installation environment so that the ambient tempera-
ture is maintained at approx. +25 °C {77 °F}. When the "Thermal
error" indication is displayed frequently, contact your dealer.
15
The clock of the recorder may keep
bad time.
• Has the built-in battery sufficiently been charged?
Charge the built-in backup battery by turning on the power for 48
hours or more.
15
• Is the built-in backup battery depleted?
The built-in battery life is around 5 years as an indication of
replacement. (The built-in battery life may become shorter
depending on the use condition.)
15
The HDD indicator is being lit red/
blinking red.
• The hard disk drive is faulty. Contact your dealer.
18
Cannot copy data on the SD memory
card.
Image data saved on the SD memory
card cannot be searched or played
back.
• Is a recommended SD memory card used?
• Some SD memory cards cannot be used with this recorder. It is
recommended to use Panasonic's SD memory card.
• Is the SD memory card formatted?
• Are data copied to the SD memory card
99
A pop-up is not displayed on the
browser.
• It may be possible that a pop-up blocker other than Internet
Explorer is activating. Check the installed software and cancel the
pop-up blocker.
–
Summary of Contents for WJ-NV200K
Page 101: ...101 ...
