41
Operations using the buttons on the front panel
■
Basic operations
The following are the available functions using the buttons on the front panel and the LCD.
The display on the LCD will shift by pressing the arrow button (up or down).
Time and date display (Standby display)
The current time & date and the internal temperature (reference value) will be
displayed.
Refer to the setup instructions (PDF) for further information.
System information display
Information about the system of the recorder will be displayed. Software version,
hardware version, MAC address and serial number can be checked. Refer to
page 42 for further information.
IP address check display
The network settings can be checked.
Press the [SET] button on the front panel while displaying this display. It is possi-
ble to check the network settings such as the IP address or the subnet mask.
Refer to page 43 for further information.
IP address setup display
The network settings can be configured.
Press the [SET] button on the front panel while displaying this display. It is possi-
ble to configure the network settings such as the IP address or the subnet mask.
Refer to page 44 for further information.
Key lock mode display
It is possible to lock the buttons on the front panel to make them unusable.
Refer to page 44 for further information.
HDD operation change display
The hard disk drives can be added/removed by following the displayed
guidance.
Refer to page 47 for further information.
This display will appear only when the [USE] button is pressed.
Manual reboot display
It is possible to reboot the recorder.
Refer to page 56 for further information.
(Temperature will be displayed in Fahrenheit for
NTSC model, e.g. "90 °F")
